Homepage | what does that do? | Common Faults | Questions Answered | Manufacturers |

Component test Programme


F 2106 & F2126

  1. Start with the selector at off 'O'
  2. Turn the selector to '6' while pressing 'Super Rinse' (Aclarado Extra) & 'Rinse Hold'.(Stop Antiarrugas)Continue holding the buttons for a count of 5.
  3. The 'Super Rinse'(Aclarado Extra), 'Rinse Hold' (Stop Antiarrugas), 'Pre-Wash'(Prelavado) & 'Wash'(Lavado)LEDs will now start flashing.
  4. Press 'Start/Reset'(Marcha Paro) for a count of 2 and the 'Super Rinse' (Aclarado Extra)& 'Rinse Hold'.(Stop Antiarrugas) LEDs will be flashing.This confirms the component test program has been started.
  5. Select a number from 2 to 8 on the selector knob which relates to the component you need to test. The relevant component list is at the bottom of this page.
  6. Press 'Start/Reset'(Marcha Paro) and the 'Super Rinse' (Aclarado Extra) & 'Rinse Hold'.(Stop Antiarrugas) LEDs will stop flashing and light permanently. This indicates the component is being tested.
  7. The part being tested will cycle on and off every 2 seconds except the door interlock which energises and de-energises as quickly as possible.
  8. This procedure will continue untill you press the 'Start/Reset'(Marcha Paro) button, then the 'Super Rinse' (Aclarado Extra) & 'Rinse Hold'.(Stop Antiarrugas) will start flashing again.
  9. Turn the selector to the next component number you need testing and press 'Start/Reset'(Marcha Paro) and this will start the test programme for that component.
  10. When you have finnished testing you can cancel all test programmes by turning the selector back to '0' and the machine will work normally when switched back on.        



Selector number
Component to be tested
Pre-wash / rinse valve
Main wash valve
Drain pump
Heater relay
Door interlock
Drum agitation (55rpm)
All the above components



If the drum does not have sufficient water (more than 6 liters) the heater will not come on because the pressure switch will isolate the neutral supply