Homepage | what does that do? | Common Faults | Questions Answered | Manufacturers |

MODULE NUMBER C00202713

Configuration information for

Creda

W200FW & W220VW

  Did you read the Module info?

Before any attempt at reconfiguring this appliance first make sure the top is on and secure (for safety reasons) and that the door is closed with the mains power switched ON

  1. Start with the selector at off 'STOP'
  2. Turn the selector to 'K' while pressing 'Rinse Hold ' & 'Energy Save'. Continue holding the buttons for a count of 5.
  3. The 'Rinse Hold', 'Energy Save' & 'Active' LEDs will now start flashing.
  4. Press 'Start/Reset' for a count of 2 and all LEDs will go out. This confirms the module configuration program has been started.
  5. Choose your model from the list below and turn the selector to the first code letter for your model.
  6. Touch the 'Start/Reset' button and the 'Rinse Hold ' LED lights to accept the code.
  7. Turn the selector to the second code letter for your model.
  8. Touch the 'Start/Reset' button and the 'Energy Save' LED lights to accept the code.
  9. Turn the selector to the third code letter for your model.
  10. Touch the 'Start/Reset' button and the 'Rinse Hold ' & 'Energy Save' LEDs light to accept the code.
  11. Turn the selector to the fourth code letter for your model.
  12. Touch the 'Start/Reset' button and the 'Energy Save ' LED lights up while the 'Rinse Hold' LED flashes to accept the code.
  13. Turn selector knob back to 'A' (anti clockwise), then slowly rotate it clockwise through all 15 positions, pausing at each one to note the condition of the 'Door Locked ' LED, (write down if it is on or off), Check the final sequence against the configuration chart for your model, if it does not correspond then re-do the whole set-up again. Once the correct configuration has been achieved turn the dial back to 'Off' and the machine will work properly next time it is switched on.

 

Model numbers and code letters

There is more than one version of module to fit these machines, if you are at all unsure it would be best to contact

Creda. on 08448-116-999

     Version 22

Model Number CODE 1 CODE 2 CODE 3 CODE 4
W200FW F Rinse & Spin H B
W220VW D K L B

  Version 23

Model Number CODE 1 CODE 2 CODE 3 CODE 4
W200FW M Spin A B
W200FW Cold Fill K E A A
W220VW K L D A
W220VW Cold Fill H B D A

 

Configuration Chart

RED = ON         WHITE = OFF

 

Version 22

Machine Number 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
W200FW                              
W220VW                              

  Version 23

Machine Number 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
W200FW                              
W200FW Cold Fill                              
W220VW                              
W220VW Cold Fill