Homepage | what does that do? | Common Faults | Questions Answered | Manufacturers |

MODULE NUMBER C00201512

Configuration information for

Fagor

F 2106 & F2126

Before any attempt at reconfiguring this appliance first make sure the top is on and secure (for safety reasons) and that the door is closed with the mains power switched ON

  1. Start with the selector at off 'O'
  2. Turn the selector to 'K' while pressing 'Super Rinse'(Aclarado Extra) & 'Rinse Hold' (Stop Antiarrugas). Continue holding the buttons for a count of 5.
  3. The 'Super Rinse ' (Aclarado Extra) & 'Rinse Hold' (Stop Antiarrugas) and 'Rinse' (Aclarado) LEDs will now start flashing.
  4. Press 'Start/Reset'(Marcha Paro) for a count of 2 and all LEDs will go out. This confirms the module configuration program has been started.
  5. Choose your model from the list below and turn the selector to the first code letter for your model.
  6. Touch the 'Start/Reset'(Marcha Paro) button and the'Super Rinse'(Aclarado Extra) LED lights to accept the code.
  7. Turn the selector to the second code letter for your model.
  8. Touch the 'Start/Reset'(Marcha Paro) button and the 'Rinse Hold' (Stop Antiarrugas) LED lights to accept the code.
  9. Turn the selector to the third code letter for your model.
  10. Touch the 'Start/Reset'(Marcha Paro) button and the 'Super Rinse'(Aclarado Extra)& 'Rinse Hold' (Stop Antiarrugas)LEDs light to accept the code.
  11. Turn the selector to the fourth code letter for your model.
  12. Touch the 'Start/Reset'(Marcha Paro) button and the 'Rinse Hold' (Stop Antiarrugas) LED lights up while the 'Super Rinse'(Aclarado Extra) LED flashes to accept the code.
  13. Turn selector knob back to '1' (anti clockwise), then slowly rotate it clockwise through all 15 positions, pausing at each one to note the condition of the 'Spin'(Centrifugado) LED, (write down if it is on or off), Check the final sequence against the configuration chart for your model, if it does not correspond then re-do the whole set-up again. Once the correct configuration has been achieved turn the dial back to 'Off' and the machine will work properly next time it is switched on.

 

Model and code numbers

         

Model Number CODE 1 CODE 2 CODE 3 CODE 4
F2106 9 (seda 30) 12 (Aclarado) 11 (Lavado Frio) 1 (Prelavado 90)
F2126 8 (Lana 40) 9 (Seda 30) 14 (Centrifugado) 1 (Prelavado 90)

 

 

Configuration Chart

RED = ON         WHITE = OFF

 

 

Machine Number 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
F2106                              
F2126