Configuration
information for
Hotpoint
WMA5P
Before
any attempt at reconfiguring this appliance first make sure the
top is on and secure (for safety reasons) and that the door is
closed with the mains power switched ON
- Start
with the selector at 'Off'
- Turn
the selector to 'K'
while pressing 'Half
Load ' & 'Economy'.
Continue holding the buttons for a count of 5.
- The
'Half
Load ',
'Economy'
& 'Active'
LEDs will now start flashing.
- Press
'Start' for a count of 2 and all LEDs will go out. This
confirms the module configuration program has been started.
- Choose
your model from the list below and turn the selector to the first code
letter for your model.
- Touch
the 'Start'
button and the 'Half
Load '
LED lights to accept the code.
- Turn
the selector to the second code letter for your model.
- Touch
the 'Start' button and the 'Economy'
LED lights to accept the code.
- Turn
the selector to the third code letter for your model.
- Touch
the 'Start'
button and the 'Half
Load '
& 'Economy'
LEDs light to accept the code.
- Turn
the selector to the fourth code letter for your model.
- Touch
the 'Start' button and the 'Economy'
LED lights up while the 'Half Load' LED flashes to accept
the code.
- Turn
selector knob back to 'A'
(anti clockwise), then slowly
rotate it clockwise through all 15 positions, pausing at each
one to note the condition of the 'Door
Locked '
LED, (write down if it is on or off), Check the final sequence
against the configuration chart for your model, if it does not
correspond then re-do the whole set-up again. Once the correct
configuration has been achieved turn the dial back to 'Off'
and the machine will work properly next time it is switched
on.
Model
number and code letters
|
CODE 1 |
CODE 2 |
CODE 3 |
CODE 4 |
WMA5P |
C |
P |
H |
B |
Configuration
Chart
RED
= ON
WHITE = OFF
Machine
Number |
1 |
2 |
3 |
4 |
5 |
6 |
7 |
8 |
9 |
10 |
11 |
12 |
13 |
14 |
15 |
WMA5P |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|