Homepage | what does that do? | Common Faults | Questions Answered |Manufacturers |

Test Program

Hotpoint Dishwasher

BFT68

 

  1. Select Reset and turn the machine OFF via the ON/OFF button
  2. Switch the dishwasher on via the ON/OFF button and you should hear a bleep, select program 1 and switch OFF. Select reset and wait for 10 seconds.
  3. Switch the dishwasher on via the ON/OFF button and you should hear a bleep, select program 2 and switch OFF. Select reset and wait for 10 seconds.
  4. Switch the dishwasher on via the ON/OFF button and you should see COR in the LCD display.
  5. Select program 1 and you should see CO1 in the LCD display. The test program will start in a few seconds

 

Stages
Function testing
1
Fill for program with motor and heater on
2
Wash motor for 5 seconds
3
Heater motor for 5 seconds
4
Dispenser for 5 seconds
5
Regeneration for 5 seconds
6
Dryer fan for 5 seconds
7
Half load for 5 seconds
8
Drain for 5 seconds
9
Dryer fan for 5 seconds
10
fill solenoid for 25 seconds

Click Here to Check out what the error codes mean

Turn the selector dial to RESET to exit the program and the buzzer will sound 4 times to signal program cancellation

If a fault code has been displayed the machine will need to be reset after it has been rectified, do this by selecting RESET on the program dial

 :