Homepage | what does that do? | Common Faults | Questions Answered |Manufacturers |

Test Program & 100 Bit control card fitting

Indesit
IDE44UK

Initializing test

  1. Make sure the machine is empty of water and the door is closed,then switch the machine on and RESET the dishwasher.
  2. Turn the control knob to program 1 and switch the machine off via the ON/OFF button and wait 30 seconds.
  3. Switch the dishwasher ON and leave the control knob at position 1 untill the display changes from 8:88 to 2:00 after 9 seconds.
  4. Switch the dishwasher off and wait untill all the lights go out.
  5. Switch the machine back on and the diplay will change from 8:88 to 2:00 after 2 seconds. Now turn the control knob to position 2 and 1:12 will show in the display
  6. Switch the dishwasher off and wait untill all the lights go out the turn the control knob to position 1.
  7. Switch the machine on and the Pre-wash and Drying symbols will flash for 5 seconds and there will be three dashes in the center of the display.
  8. For the short test leave the control knob at position 1 and press the START/RESET button this will show 'rod' in the display.
  9. For the long test turn the control knob to position 2 and press the START/RESET button this willl show iether SAT or CO1 in the display (depending on the card version in your machine)
  10. The tests will finnish when the display shows END or a fault is detected, in which case an error code will show in the display.

 

Test No:
(Short Test)Lasts approximately 5 minutes
Test No:
(Long Test)Lasts approximately 15 minutes
1
Fill to Level
1
Fill to level, circulate and heat to temp (55°C)
2
Circulation
2
Drain
3
Heat
3
Fill and Circulate
4
Dispenser operated
4
Dispense rinse aid
5
Regenerate
5
Circulate
6
Half Load
6
Regenerate
7
Drain
7
Drain, then fill and stop
8
Drying
 
9
Fill and Stop
 

If a fault is detected the machine will display an Error code check it against our data base to find out what it means

Turn the selector dial to RESET to exit the program


 

Cancel factory test

On fitting a 100 bit control card it could automatically go into a factory test cycle. The following procedure will eliminate this test cycle. All these actions must be carried out quickly.

  1. Close the door and switch the dishwasher on
  2. Wait untill the test cycle starts
  3. Leave the door closed and switch the dishwasher OFF...
  4. Wait for exactly 15 seconds then switch the dishwasher ON
  5. Open the door and press the reset button untill you hear three bleeps
  6. This has now reset the test cycle and the machine is ready for normal use