Homepage | what does that do? | Common Faults | Questions Answered | Manufacturers |

Control Module Specification Change

The Original control modules (part number C00199331) had a ten way plug connection for the pressure switch, pump & fill vales. After Date code 81 (Sept 2000) this was changed to a six, two, two set of three plugs. A machine manufactured after DC81 will not accept a 10 way board. However, an original machine with a 10 way plug will fit onto either board.

The date code is usually located on the inside edge of the door trim. Use this Date Code link to check if your machine falls within the boundaries of the relevant specifications.